I’m trying to record 16 tracks at the same time.
Software: Cubase 9.5 Artist/Elements
Hardware: UR824
Second preamp: Behringer ADA8000
Setup: two ADAT cables and one coax - ADAT using the ADAT A in and out
I set up a bus for each channel. The channels associated with the UR824 work just fine. The ADAT connections seem to be working to control the ADA8000, which is set in slave mode. The “locked” light illuminates. The lights that indicate a signal is into the ADA8000 light up at each channel, but nothing makes it to Cubase. Each channel for the ADA8000 is set up with a bus: ADAT A in 1, ADAT A in 2, ADAT A in 3, etc.
What am I doing wrong? I cannot find a disconnected light pipe or any other obvious issue. It has to be some setting that I’m doing wrong.