What is the way to get mixed out AXR4 audio signal in Cubase in order to record it ?
I don’t see any bus in the audio connexions window which allows me to do it…
Thank you for help !
I have just been doing a hard patch from two of the outputs to two of the inputs.
Thank you for response
OK… but with this way, the audio signal has to go through 2 converters instead to be get just directly after mix.
Until today, I worked with a O1V Yamaha and it is easily possible to get the mixed signal…
Is there no a similar way with AXR4 ?
Best regards
p.s. I apologize for bad english
I don’t own the unit but check pages 36 and 41 in the manual re loopback options