Hi, I was wondering … can I add an automatization parameter to all tracks in one go ?
I can not find it in the manual … if it’s possible of course …
Thanks in advance for your answers …
Greetz Bart
Hi, I was wondering … can I add an automatization parameter to all tracks in one go ?
I can not find it in the manual … if it’s possible of course …
Thanks in advance for your answers …
Greetz Bart
Link all tracks and choose the appropriate parameter as well, write-enable all and then touch the parameter on one track?
Maybe the “Create Initial Parameter Events” function is what you are looking for?
In the Automation Panel → Functions → Create Initial Parameter Events
Hi MattiasNYC … linking … no succes … I tried all kinds of link settings … but … no …
And Hi hendrix97 … no succes either with the “Create Initial Parameter Events” …
Other suggestions ? Shoot ! …
Greetz
Bart
I suppose you want them all visible for manual editing the automation lines.
A little unconventional if I may say …
You can use a workaround though.
Link all channels, and write just a small part of automation. For the sake of the example, say panning.
Since all channels are linked (if properly linked that is - See linking options) it will write panning automation on all channels.
Unlink and perform a Show used automation on (selected) tracks.
Fredo
Hi, thanks for the reply … I will try it later this week …
Greetz
Bart
PS sorry for the late reply …