Xerxes
May 25, 2020, 5:50am
33
Can you check to see if you have insert fx insert activated in dspMixFX and check to see if the input level is has been turned down. See attached. It’s on Mac here but its the same on Windows.
insert-fx.jpg
dspmixfx.jpg
With the correct settings in dspmixfx I have no issues with levels. What you can expect with the Rode is with the input at 50% (wouldn’t suggest any higher re noise floor issues) and dspmixfx either set to the default shown or switched off, you should not have any issues monitoring through your headphones, assuming your headphones are of the correct impedance for the UR44.
Hoe this helps.
Steve
I have never used dspMixFX. I didn’t even know it was installed. Must have came with the drivers. I did not have any FX turned on and all the volume levels are the same as yours.