First off. thank you for the reply and help. I had no chance to reply before that.
Ok so following your instructions:
-
To make sure my front input is setup as mono, I go to F4 (VST Connections Inputs), right click, add bus, mono. And in the device section, I select Pro24-004 c60 IP2 which is supposed to be my front port
-
To ‘‘record this mono input to a cubase ‘‘stereo’’ audio track’’ I added a stereo track. Click click, add audio track, select stereo.
-
the output is by default ''stereo out"
The bass is playing fine I ear it in both monitors, still, I just can’t pan it, at all. If I move the slide from from center position to left, it just stays centered, no panning, no change. If I move the panning slider from center position to right it just fades out until reaching 0 at far right position…
I really don’t know where the problem is…
thanks a whole lot for your precious time