Strip knobs not displayed if using Novation Automap

Cubase
1

Hi, I want to report this misbehaviour I found using Cubase 7.0.2 (running at 64 bits on OSX 10.8.2) with Novation Automap 4.5.0.

If, in the VST3 section of Automap software setup, I enable the wrapping of “Cubase Plug-in Set”, then the strip knobs are not displayed. They display correctely as long as I disable the wrapping (but obviously I can’t control Cubase’s fx using my Nocturn anymore, unless I use it as a normal midi controller with the Generic Remote or I map the fx on the new Remote Control Editor).

I’m going to report the issue also to Novation.

2

Hi Sin Night,

Thanks for your thread.

Has your issue been fixed in the meantime?

Do you have a case number?

Please let me know, if I can be of any further assistance to you.

With best regards,

Marcel // Novation Technical Support

3

Hi, Thank You very much for your care!

I reported the issue to your technical support (I have a case number), I’ve been confirmed of the problem and I’ve been told that it will be fixed in a future version of Automap.
As today the issue is not fixed yet, but I’m cool with it as I can imagine this bug requires a good amount of new code in order to handle these new features of Cubase. :wink:

Best Regards,
Antonio

4

It’s Ok here

5

Hi Antonio,

Thanks for your reply.

You may want to pass me on your case number.

With best regards,

Marcel // Focusrite Novation Support