This gives me an idea then… so I could create two tracks. One track is just to monitor the live input and load my effects while mastering… And the other track is where I place the finished clips after I record them. That track would have no track effects, but only the clip effects after they have been finished. Then in order to switch back and forth, I would just use the solo button on either track… this just might work. I will try and report back soon!
Todd
Agreed, this would be cool… but in my case above, track monitoring would always be enabled on the live input track. In order to switch back-and-forth I would need to enable the solo button on one track or the other… so there would have to be a key command to enable solo on track one, and another key command to enable solo on track two, etc.