Thank you for your response question…
My VST meter shows about 55% load with all my reverence reverbs are on. They real time peak is always bouncing to the max no matter if I have the reverbs on or off. Taking off the Reverence reverbs does clean it up but even when I add just 1 it starts to pop. The weird thing about it is, it didn’t start popping until much later after I had added those reverbs. So it wasn’t that obvious when trouble shooting but when I finally turned off all VST efx and then slowly added each one back one by one I was able to isolate it down to that specific effect.
My Latency settings are - 5ms on Input and 7ms on output.
Is there a way to increase VST performace? My cpu’s are only using about 25% on average with everything on.
Thanks for any help you can give.
jc