MI4 on Win10

For users of legacy Steinberg hardware
Post Reply
Bolbou1
New Member
Posts: 12
Joined: Sat Dec 07, 2013 11:17 pm
Location: Poland
Contact:

MI4 on Win10

Post by Bolbou1 » Sun Feb 28, 2016 1:44 pm

Hello.
Does anyone know a way to start the MI4 drivers for Windows 10?
So far, I can not do this.
At win7 everything works, but for W10 errors.
Or maybe unfortunately this is not possible and I can only work on W7?

tnx.
Cubase 9.5.20 Pro 64bit - 10pro installs in a few moments, WavelLab 8 elements,
M-Audio Fast Track Ultra 8R, Presonus FaderPort, AKG Perception 100, RODE NT2-A
EWQL Goliath, Ample Sound giutars, Kontakt 5 libraries, Halion Sonic 3, HALion 6, PSP plugs
KRK Rokit 6
Roland FA08, Korg M50, Roland A-30
other stuff
-----
i7 4770k
16GB ram 1600mHz
Asus GTX660TI
Windows 10 Home 64bit on Crucial MX300 SSD

Bolbou1
New Member
Posts: 12
Joined: Sat Dec 07, 2013 11:17 pm
Location: Poland
Contact:

Re: MI4 on Win10

Post by Bolbou1 » Fri Mar 25, 2016 4:24 pm

Does not anyone use MI4 on Win 10?
Cubase 9.5.20 Pro 64bit - 10pro installs in a few moments, WavelLab 8 elements,
M-Audio Fast Track Ultra 8R, Presonus FaderPort, AKG Perception 100, RODE NT2-A
EWQL Goliath, Ample Sound giutars, Kontakt 5 libraries, Halion Sonic 3, HALion 6, PSP plugs
KRK Rokit 6
Roland FA08, Korg M50, Roland A-30
other stuff
-----
i7 4770k
16GB ram 1600mHz
Asus GTX660TI
Windows 10 Home 64bit on Crucial MX300 SSD

SwedeMetal
New Member
Posts: 1
Joined: Fri Apr 29, 2016 8:05 pm
Contact:

Re: MI4 on Win10

Post by SwedeMetal » Fri Apr 29, 2016 8:24 pm

Yes, but not sure if it works with Cubase (especially Cubase 2.0). I have been using my MI4 with the following setup:

Reaper DAW 4.78-64bit
Windows10-64bit
Steinberg MI4 2.8.14.1 driver and 1.0.6 firmware

I recently went back to W7-64bit due to W10 instabilities unrelated to music production.

mplaksant
New Member
Posts: 3
Joined: Wed Jun 29, 2016 1:49 pm
Contact:

Re: MI4 on Win10

Post by mplaksant » Wed Jun 29, 2016 2:33 pm

hey guys, how you managed to get MI4 work in Windows 7??

nbevan3
New Member
Posts: 19
Joined: Wed Dec 17, 2014 9:32 pm
Contact:

Re: MI4 on Win10

Post by nbevan3 » Thu Jan 10, 2019 2:19 pm

mplaksant wrote:
Wed Jun 29, 2016 2:33 pm
hey guys, how you managed to get MI4 work in Windows 7??

Mine was working perfectly until I updated the Firmware to 1.06 now it does not boot on win7 or win10.
Also NO RESPONSE from Steinberg (I suspect they will say it is not supported now but it would be nice to hear that rather than just assume that to be the case!)

phlake
New Member
Posts: 1
Joined: Thu Jan 17, 2019 2:20 pm
Contact:

Re: MI4 on Win10

Post by phlake » Thu Jan 17, 2019 2:25 pm

My MI4 died after the latest Win10 update. It has been working until october, but was rendered useless after the fall update. I tried every trick in the book, but when reinstalling the good old vista64-drivers, the device shows up as "normal" in the playback devices, but when I check the devicemanager, it "requires further installation" and is "not migrated". I really hope that Steinberg will provide an updated driver for this, because it's really not good for anyone if we have to throw away our MI4s and invest in a new device, since it's actually a great soundcard. The environment cries.

manyasone
New Member
Posts: 1
Joined: Sun Apr 14, 2019 2:43 pm
Contact:

Re: MI4 on Win10

Post by manyasone » Sun Apr 14, 2019 2:49 pm

Hi,

in the past I ran into the same problem and didn't expect the MI4 to be fully working under Windows 10 again. I could use it, but only without installing the drivers, and therefore without being able to change settings in the control panel.

But just now I succeeded in reaminating my MI4! What I did:
- Upgrade the MI4 firmare (I don't know, if anything was "upgraded" at all, or if the old upgrade was just overwritten)
- Unplug the MI4
- Uninstall the MI4 drivers (without rebooting)
- Install the MI4 drivers using "Windows Viste Service Pack 2" compatibility mode, following the installation instructions (plug it in when prompted, etc.

I have no clue, why it's working again all of a sudden, but maybe this can be of help for someone else.

SXARmusic
New Member
Posts: 1
Joined: Mon Apr 22, 2019 6:36 pm
Contact:

Re: MI4 on Win10

Post by SXARmusic » Mon Apr 22, 2019 6:51 pm

Manyasone,

Do you know if it's possible to simply run the interface as solely a sound card? Like I purchased the interface today, but i don't have an XLR mic or a guitar to plug it into yet. I was just planning on using it to run my headphones through, and buying other accessories when i have the money. The control panel has a direct route from the usb from host to phones, but There's a "DA Conv." in the way. I'm not sure what this is or how to bypass it. Help?

rochxa
New Member
Posts: 1
Joined: Sat Jul 20, 2019 11:42 pm
Contact:

Re: MI4 on Win10

Post by rochxa » Sun Jul 21, 2019 3:40 am

I followed the manyasone tips and it worked perfectly. I'm even using the protools Ultimate 2019 in it. It was awesome.
hahahaha I'm happy!
Attachments
2019-07-21 (5).png
(574.75 KiB) Not downloaded yet
2019-07-21 (4).png
(215.92 KiB) Not downloaded yet
2019-07-21 (3).png
(239.03 KiB) Not downloaded yet

Post Reply

Return to “Legacy Steinberg Hardware”

Who is online

Users browsing this forum: No registered users and 1 guest